Share |

Thursday, May 27, 2010

S1, S2, R1 AND R2...? An Objective Alternative

As already stated, the pivot point zone is a well-known technique and it works simply because many traders and investors use and trust it. But what about the other support and resistance zones (S1, S2, R1 and R2,) to forecast a support or resistance level with some mathematical formula is somehow subjective. It is hard to rely on them blindly just because the formula popped out that level. For this reason, we have created an alternative way to map our time frame, simpler but more objective and effective.

We calculate the pivot point as showed before. But our support and resistance levels are drawn in a different way. We take the previous session high and low, and draw those levels on today’s chart. The same is done with the session before the previous session. So, we will have our PP and four more important levels drawn in our chart.

LOPS1, low of the previous session.
HOPS1, high of the previous session.
LOPS2, low of the session before the previous session.
HOPS2, high of the session before the previous session.
PP, pivot point.

These levels will tell us the strength of the market at any given moment. If the market is trading above the PP, then the market is considered in a possible uptrend. If the market is trading above HOPS1 or HOPS2, then the market is in an uptrend, and we only take long positions. If the market is trading below the PP then the market is considered in a possible downtrend. If the market is trading below LOPS1 or LOPS2, then the market is in a downtrend, and we should only consider short trades.

The psychology behind this approach is simple. We know that for some reason the market stopped there from going higher/lower the previous session, or the session before that. We don’t know the reason, and we don’t need to know it. We only know the fact: the market reversed at that level. We also know that traders and investors have memories, they do remember that the price stopped there before, and the odds are that the market reverses from there again (maybe because the same reason, and maybe not) or at least find some support or resistance at these levels.

What is important about his approach is that support and resistance levels are measured objectively; they aren’t just a level derived from a mathematical formula, the price reversed there before so these levels have a higher probability of being effective.

This mapping method works on both market conditions, when trending and on sideways conditions. In a trending market, it helps us determine the strength of the trend and trade off important levels. On sideways markets it shows us possible reversal levels.

How we use our mapping method?
We use the mapping method in three different ways: as a trend identification (measure of the strength of the trend), a trading system using important levels with price behavior as a trading signal and to set the risk reward ratio of any given trade based on where the is the market relative to the previous session.

About the author:
Raul Lopez is a full time Forex trader; his trades are based on a price behavior approach. Raul is also founder of http://www.straightforex.com aForex training company.

No comments:

Post a Comment

Please Wait